BMP085 Barometric Pressure/Altitude Sensor w/ I2C

The BMP085 from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature as well as altitude. Interfaces to the MCU via I2C interface and is designed to work with 3.3V and 5V systems, equipped with 3.3V regulator, I2C level shifter and the pull-up resistors for the I2C pins.

More details

LB-1085
New

 
More info

The BMP085 from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature as well as altitude. This Module consists of the BMP085 silicon and is designed to work with 3.3V and 5V systems, equipped with 3.3V regulator, I2C level shifter and the pull-up resistors for the I2C pins.

 

The sensor is based on piezo-resistive technology for EMC robustness, high accuracy and linearity as well as long term stability.

 

This module outputs data i.e. barometric pressure and temperature via I2C interface and altitude can be calculated based on the barometric pressure reading. In addition, the module also has pin broken out for EOC (End of Conversion) and XCLR (master clear input).

 

Feature of BMP085 are:

  •          Pressure sensing range: 300-1100 hPa (9000m to -500m above sea level)
  •          Low Altitude Noise :Up to 0.06hPa / 0.5m resolution in ultra low power mode

Up to 0.03hPa / 0.25m resolution in ultra high resolution mode

  •          -40 to +85°C operational range, +-2°C temperature accuracy for temperature measurements

 

Comes fully assembles and Tested with your choice of 7 Pin 0.1” (2.54 mm) header of your choice - Male 180°, Female 180° ,Male 90°, Female 90° (If you want a header of your choice , please leave a message in the order page in my account section. Else, it will be shipped with Male 180° header). 

Write a review

BMP085 Barometric Pressure/Altitude Sensor w/ I2C

The BMP085 from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature as well as altitude. Interfaces to the MCU via I2C interface and is designed to work with 3.3V and 5V systems, equipped with 3.3V regulator, I2C level shifter and the pull-up resistors for the I2C pins.

Write a review

 
Comments

No customer comments for the moment.