ENC28J60 Based 10Base Ethernet Module w/ SPI

The ENC28J60 Ethernet Module is cute little module for adding 10Base Ethernet fast and easily to your project. With just a few pins you can use this module via SPI interface. This module contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS LEDs. Works from 3.3V with 5V tolerant I/Os and has an 8-Kbyte buffer.

More details

LB-2860
New

 
More info

The ENC28J60 Ethernet Module is cute little module for when you need to add Ethernet functionality to your project and serves as a great option to get started with Ethernet for embedded systems. ENC28J60 is a stand-alone 10Base Ethernet controller with industry standard SPI interface. It is fully compatible with 10/100/1000Base-T Networks.

 

The ENC28J60 works on 3.3V but the I/Os are 5V tolerant making it ideal for using it with your favorite MCU. It also consists of an 8-Kbyte buffer.

 

The Features of the ENC28J60 IC are :

 

  •          IEEE 802.3™ Compatible Ethernet Controller
  •          Fully Compatible with 10/100/1000Base-T Networks
  •          Integrated MAC and 10Base-T PHY
  •          Supports One 10Base-T Port with Automatic Polarity Detection and Correction
  •          Supports Full and Half-Duplex modes
  •          Programmable Automatic Retransmit on Collision
  •          Programmable Padding and CRC Generation
  •          Programmable Automatic Rejection of Erroneous Packets
  •          SPI Interface with Clock Speeds up to 20 MHz

 

With just a few pins you can use this module via SPI interface. This module contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS LEDs.

 

Whether you want to serve some html pages or ping the module or use it as a http client to send GET requests etc. You can do it all with this Lil’ module which uses integrated magnetics RJ45 connector making the size of the module even smaller.

 

This Module comes fully assembled and tested with your choice of 5 pin 2 row 0.1” (2.54 mm) header of your choice - Male 180°, Female 180° ,Male 90°, Female 90° (If you want a header of your choice , please leave a message in the order page in my account section. Else, it will be shipped with Male 180° header). 

Write a review

ENC28J60 Based 10Base Ethernet Module w/ SPI

The ENC28J60 Ethernet Module is cute little module for adding 10Base Ethernet fast and easily to your project. With just a few pins you can use this module via SPI interface. This module contains all the necessary hardware to implement an Ethernet interface including the isolation transformer and LINK/STATUS LEDs. Works from 3.3V with 5V tolerant I/Os and has an 8-Kbyte buffer.

Write a review

 
Comments

No customer comments for the moment.